Installing a custom steering wheel safely: airbag, clock spring and controls
A custom carbon fiber steering wheel reuses your airbag and controls. The safety steps, the clock spring and the mistakes that cause airbag lights.

A custom carbon fiber steering wheel transforms the feel of a Charger, Challenger, Durango, Ram or Jeep. Most custom wheels, including the ones we sell, are designed to reuse your factory airbag, buttons and paddle shifters. That makes installation straightforward, but it also means you’re working with a live safety system. Here’s how to do it correctly.
Important: airbags are explosive devices. If you’re not comfortable with the steps below, have a qualified installer or dealer do the swap. Never test, probe or disassemble an airbag module.
Before you start
- Read the instructions supplied with your wheel and your vehicle’s service information. They take priority over this general guide.
- Park with the wheels pointing straight ahead and the steering wheel centered. Don’t turn the steering once the wheel is off, or you can damage the clock spring.
- Disconnect the negative battery cable and wait the time specified in the service information, commonly a couple of minutes or more, so the airbag system’s backup power discharges.
Removing the factory airbag
- Locate the release access points on the back or sides of the steering wheel.
- Release the airbag module and lift it away carefully.
- Disconnect the airbag connectors and the horn and switch connectors. Note their positions with a photo.
- Place the airbag face up on a clean surface, away from heat. Never set it face down, and never carry it with the cover facing your body.
The clock spring
Behind the wheel is the clock spring, a coiled ribbon cable that keeps the airbag and switches connected while the wheel turns. If it’s turned past its limits while the wheel is off, it can tear, causing an airbag warning light and dead horn or switches.
- Keep the clock spring centered throughout the job.
- If your airbag light was already on, or the horn and buttons were intermittent, the clock spring may already be worn. Replace it during the swap. We list clock springs by part number.

Swapping the wheel
- Mark the steering wheel’s position on the shaft, then remove the retaining bolt.
- Pull the wheel straight off. Some need a puller. Don’t hammer on the shaft.
- Transfer the switches, paddles and trim to the new wheel as the instructions describe.
- Install the new wheel on the splines centered, torque the bolt to spec (often with a new bolt).
- Reconnect switches, horn and the airbag connector until each clicks. Then seat the airbag.
- Reconnect the battery with nobody in the vehicle, turn the ignition on and check that the airbag light comes on briefly and then goes out.
If the airbag light stays on
Don’t drive the vehicle as if the airbag will work. Check that every connector is fully seated, verify the clock spring, and have the system scanned. Many airbag codes need to be cleared with a scan tool after the fault is fixed.
LED shift lights and extra features
Wheels with LED shift lights or displays need an extra connection, depending on the design. Follow the supplied instructions exactly. Our guide to paddle shifters and LED shift lights explains how these features work.
Choosing a wheel? Start with our carbon fiber steering wheel buying guide, then browse steering wheels by vehicle.


